Lennox Hearth Oven LSS CA35 User Manual

HEARTH PRODUCTS  
KITS AND ACCESSORIES  
750,150M REV N/C 8/2002  
CAST IRON  
FACADE KITS  
LENNOX HEARTH PRODUCTS  
INSTALLATION INSTRUCTIONS FOR CAST IRON FACADE KITS  
Model Numbers LSS-CA35 (H0378) and LSS-CA40 (H0398)  
FOR USE WITH SPECTRA LSS SERIES GAS FIREPLACES  
GENERAL INFORMATION  
Step 3. Hook the two cast iron side pieces onto the fireplace side  
channels as shown in Figure 2. If the fit is too tight or loose,  
adjust the gap of the two holding screws. (See Figure 1.)  
These cast iron facade kits are designed to be used in conjunction with  
the grillwork kits. Together, when installed, these kits complete the front  
aspect of the Spectra LSS series gas fireplaces. The kits contain one  
of each of the following cast iron facade pieces: bottom, top, left and  
right piece. They also contain four 1/2 inch long 1/4-20 facade holding  
screws, four 1-1/2 inch long 1/4-20 facade holding screws and these  
instructions.  
Side Piece  
Cast iron side piece screw head  
hooked behind top portion of shown  
fireplace side channel detail  
INSTALLATION INSTRUCTIONS  
(top and bottom same method).  
Step 1. Install the top and bottom grills to their corresponding top  
and bottom cast iron facade pieces as detailed in the  
installation instructions provided with the grillwork kits.  
Step 2. Install four kit-provided facade holding screws to each of the  
two side pieces ensuring compliance with the gaps shown in  
Figure 1.  
1/2 inch long Cast Iron Side Piece Holding Screws  
3/32 inch  
1-1/4 inch  
(2.38 mm)  
(31.8 mm)  
Note: The left cast iron side piece (shown above) is sloped upward  
at the top, from left to right, to form a mating fit to the arched cast iron  
top piece. The right cast iron top piece has the opposite slope at the top.  
Figure 2  
Installing Cast Iron Side Pieces  
1-1/2 inch long Cast Iron Bottom Piece Holding Screws  
1/2 inch long,  
1/4-20 Facade Holding Screws  
1-1/2 inch long,  
1/4-20 Facade  
Holding Screws  
Cast Iron Side Piece  
Figure 1  
Screw Head to Facade Side Piece Gap  
and Fastener Usage.  
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.  
 

KTI Networks TV Converter Box KCD 400 User Manual
KWC Indoor Furnishings S10J101 User Manual
Lenovo Laptop MIIX 2 8 User Manual
LG Electronics Blu ray Player BD670 User Manual
LG Electronics Cell Phone UX245 User Manual
LG Electronics Clothes Dryer D 5988 B User Manual
Life Fitness Treadmill Next Generation Treadmills User Manual
LifeSource Blood Pressure Monitor UA 767T User Manual
Magnavox VCR VR201BMG User Manual
Metra Electronics Automobile Accessories 99 8227S User Manual