Manitowoc Ice Ice Maker B 0320 User Manual

Installation Instructions  
This kit includes a water splash shield and clips. These can be installed together or separately to eliminate the  
possibility of water tracking on the bottom of the left or right evaporator brackets to the back wall where it  
could flow into the ice bin instead of back into the water trough.  
INSTALLATION OF LEFT AND RIGHT CLIPS  
1. Remove bin switch from its mounting position (depress locking tab and slide bin switch out).  
2. Slide right side clip onto right evaporator bracket, as shown. Clip must be positioned towards front  
of evaporator bracket (bottom flange of clip must be located inside water trough).  
3. Reassemble bin switch onto evaporator bracket.  
4. Install left side clip onto left side evaporator bracket.  
IMPORTANT: B-0320/B-0420 models only – clips cannot be installed on B-0320 and B-0420 models.  
Splash shield must be installed to prevent water tracking.  
INSTALLATION OF WATER SPLASH SHIELD  
1. Loosen bottom evaporator mounting screws.  
2. Peel off backside of tape and slide splash shield between backside of evaporator and wall. Position  
splash shield into water trough so that all the water is deflected back into the trough.  
3. Tighten evaporator mounting screws.  
Manitowoc Ice, Inc.  
2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA  
8009883  
Telephone 920-682-0161, Fax – Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879  
Rev. 08/25/97  
 

KWC Indoor Furnishings K18P221 User Manual
Lasko Fan 675900 User Manual
LeapFrog Baby Toy 605 10217 B User Manual
Life Fitness Elliptical Trainer CSX 01 User Manual
Lowrance electronic GPS Receiver ELITE 4M User Manual
Makita Cordless Drill 6223DE User Manual
Makita Drill 8390DWAE User Manual
Maytag Clothes Dryer MGD3000B User Manual
MB QUART Car Speaker PSD 216 User Manual
Mellerware Hot Beverage Maker 22400RDA User Manual